LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Interior Trim And Ornamentation) >> Removal And Installation >> Headliner - SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Remove the RH and LH sun visor screws and the sun visors.
    • If equipped, disconnect the electrical connectors.
      Fig 1: Locating Sun Visor Screws
      G07485557Courtesy of FORD MOTOR CO.
  3. Remove the RH and LH sun visor retaining clips.
    • Remove the sun visor clip retaining screws.
      Fig 2: Locating Sun Visor Retaining Clips
      G07485558Courtesy of FORD MOTOR CO.
  4. Remove the RH and LH A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL .
  5. Remove the RH and LH B-pillar trim panels. For additional information, refer to B-PILLAR TRIM PANEL - SUPERCAB .
  6. Remove the RH and LH garment hooks.
    • Open the garment hook screw access covers.
    • Remove the 2 garment hook screws.
  7. Disconnect the headliner electrical connector located behind the upper B-pillar trim panel.
  8. Remove screws and the RH and LH rear door latch covers.
  9. Fully recline the front seat backs.
  10. NOTE: Make sure not to crease the headliner when removing it from the vehicle.

    With an assistant, remove the headliner through the door opening.

  11. To install, reverse the removal procedure.