LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Interior Trim And Ornamentation) >> Removal And Installation >> Headliner - Regular Cab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH and LH A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL .
  2. Remove the RH and LH B-pillar trim panels. For additional information, refer to B-PILLAR TRIM PANEL - REGULAR CAB .
  3. Remove the RH and LH sun visor screws and the sun visors.
    • If equipped, disconnect the electrical connectors.
      Fig 1: Locating Sun Visor Screws
      G07485557Courtesy of FORD MOTOR CO.
  4. Remove the RH and LH sun visor retaining clips.
    • Remove the sun visor retaining clip screws.
      Fig 2: Locating Sun Visor Retaining Clips
      G07485558Courtesy of FORD MOTOR CO.
  5. Disconnect the headliner electrical connector located behind the upper B-pillar trim panel.
  6. Fully recline the front seat backs.
  7. Remove the RH and LH garment hooks.
    • Open the garment hook screw covers.
    • Remove the garment hook screws.
  8. NOTE: Make sure not to crease the headliner when removing it from the vehicle.

    With an assistant, remove the headliner through the door opening.

  9. To install, reverse the removal procedure.