Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the overhead console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Remove the RH and LH front seats. For additional information, refer to SEATING .
- Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Remove the RH and LH sun visor screws and the sun visors.
- If equipped, disconnect the electrical connectors.
- Remove the RH and LH sun visor retaining clips.
- Remove the sun visor retaining clip screws.
- Remove the RH and LH A-pillar trim panels. For additional information, refer to A-PILLAR TRIM PANEL .
- Remove the RH and LH B-pillar trim panels. For additional information, refer to B-PILLAR TRIM PANEL - CREW CAB .
- Remove the RH and LH garment hooks.
- Open the garment hook screw access covers.
- Remove the 2 garment hook screws.
- Remove the RH and LH C-pillar trim panels. For additional information, refer to C-PILLAR TRIM PANEL - CREW CAB .
- Disconnect the headliner electrical connector located behind the upper C-pillar trim panel.
-
NOTE: Make sure not to crease the headliner when removing it from the vehicle.
Remove the headliner.
- With an assistant, remove the headliner through the RH front door opening.
- To install, reverse the removal procedure.