Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Right side shown, left side similar.

Open the A-pillar trim panel bolt covers.
Loosen the A-pillar trim panel bolts.
- To install, tighten to 8 Nm (71 lb-in).
  
  Fig 1: Identifying A-Pillar Trim Panel Bolts
  Courtesy of FORD MOTOR CO.
NOTE: Carefully rotate the A-pillar trim panel during this step.

Remove the A-pillar trim panel.
To install, reverse the removal procedure.