Wheel Speed Sensor Ring - Rear, Four-Channel: Removal
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear wheel hub. For additional information, refer to WHEEL HUBS AND BEARINGS - FULL FLOATING AXLE - FORD .
- Using the Step Plate and the 2 or 3 Jaw Puller, remove the wheel speed sensor ring.
- Clean any dirt or foreign material from the wheel speed sensor ring contact area on the wheel hub.