LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 355 (Anti-Lock Brake System & Stability Control) >> Removal And Installation >> Wheel Speed Sensor Ring - Rear, Four-Channel >> Installation

Wheel Speed Sensor Ring - Rear, Four-Channel: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the wheel speed sensor ring on the rear wheel hub.
  2. Place a block of wood on top of the wheel speed sensor ring and install the ring by gently and evenly tapping the wood block with a hammer.
    Fig 1: Placing Block Of Wood On Top Of Wheel Speed Sensor Ring
    G08596632Courtesy of FORD MOTOR CO.
  3. Install the rear wheel hub. For additional information, refer to WHEEL HUBS AND BEARINGS - FULL FLOATING AXLE - FORD .
scientia non olet · About LEMON Manuals