Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Clean off any dirt or foreign material that may have collected around the wheel speed sensor before removal to prevent contamination of the axle lubricant. Failure to follow this instruction may result in damage to the rear axle.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the wheel speed sensor electrical connector.
-
NOTE: The wheel speed sensor is constructed from plastic, excessive force may damage the wheel speed sensor.
Remove the wheel speed sensor bolt and the sensor.
- To install, tighten to 20 Nm (177 lb-in).
- To install, reverse the removal procedure.