Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Disconnect the wheel speed sensor electrical connector.
- Detach the wheel speed sensor harness from the rear axle.
- Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 20 Nm (177 lb-in).
- To install, reverse the removal procedure.