Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use a small thin-bladed tool (such as a pocket screwdriver) to release the upper tabs of the running board lamp from the running board.

Release the tabs and remove the running board lamp.
- Disconnect the electrical connector.
- If necessary, rotate the bulb holder one-eighth turn counterclockwise and remove it from the running board lamp.
To install, reverse the removal procedure.