Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, JACKING & LIFTING .
Remove the 4 bolts and the front bumper bracket.
- To install, tighten to 48 Nm (35 lb-ft).
Disconnect the fog lamp assembly electrical connector.
Remove the 3 fog lamp bracket bolts and remove the fog lamp bracket and the fog lamp assembly.
- To install, tighten to 5 Nm (44 lb-in).
To install, reverse the removal procedure.
- Transfer parts as necessary.
- If necessary, adjust the fog lamps. For additional information, refer to FRONT FOG LAMP ADJUSTMENT .