Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The bulb contains gas under pressure. The bulb may shatter if the glass envelope is scratched or if the bulb is dropped. Handle the bulb only by its base. Avoid touching the glass envelope. Failure to follow these instructions may result in personal injury.

NOTE: The fog lamp bulb should not be removed from the fog lamp until just before a new bulb is installed. Removing the bulb for an extended period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they can settle on the lens and reflector. Never turn on the fog lamps with the bulb removed from the fog lamp.

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, JACKING & LIFTING .
Disconnect the fog lamp electrical connector.
Rotate the fog lamp bulb counterclockwise approximately one-eighth turn and remove it.
To install, reverse the removal procedure.