LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 338 (Information Center - Instrumentation, Message Center, And Warning Chimes) >> Removal And Installation >> Instrument Panel Cluster (IPC) >> Installation

Instrument Panel Cluster (IPC): Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the IPC in the instrument panel, connect the electrical connector and install the 2 screws.
  2. If equipped, connect the electrical connectors, position the IPC finish panel and install the 4 screws.
  3. Install the lower instrument panel steering column cover.
  4. Install the 2 gap hider push pins from the steering column.
  5. If equipped with an automatic transmission, place the selector level in PARK (P).
  6. Install the upper instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  7. If installing a new IPC, download the IPC configuration information from the scan tool into the new IPC. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals