F-450 and F-550: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

For model 80, using the Rear Axle Drawbar and the Rear Wheel Hub Bearing Cup Installers 205-100 and 205-480, install the inner and outer bearing cups. For model S110 or S130, use a suitable driver.
- Check to see if a 0.038 mm (0.0015 in) feeler gauge can be inserted between the cups and the rear hub at any point around each cup. Reseat the bearing cups, if necessary.
  
  Fig 1: Locating Inner And Outer Bearing Cups
  Courtesy of FORD MOTOR CO.
Install the inner rear wheel bearing in the rear hub.
Install a new rear hub seal.
- For model 80, use a suitable seal installer.
- For model S110 or S130, use the Wheel Hub Inner Wheel Installer and Adapter.
  
  Fig 2: Installing Rear Hub Seal
  Courtesy of FORD MOTOR CO.
Position the rear brake disc on the rear hub and install the 8 bolts.
- Tighten to 155 Nm (114 lb-ft).
  
  Fig 3: Locating Rear Hub Bolts
  Courtesy of FORD MOTOR CO.
Install the rear wheel hub. For additional information, refer to WHEEL HUB .