LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 335 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal

Front Brake Caliper Anchor Plate: Removal

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
NOTE: F250, F350 shown, F450, F550 similar.
  1. Remove the brake pads. Refer to BRAKE PADS .
    • To install F-250, F-350, tighten the new bolts to 225 Nm (166 lb-ft).
    • To install F-450, F-550, tighten the new bolts to 350 Nm (258 lb-ft).
      G08601687
scientia non olet · About LEMON Manuals