LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (HVAC - Climate Control System - General Information And Diagnostics -- F250-F550 Super Duty) >> General Procedures >> Heater Hose Coupling >> Connect

Heater Hose Coupling: Connect

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the tubes and lubricate with plain water.
  2. Install a new coupling retainer, spacer and lubricated O-ring seals into the quick disconnect coupling housing.
    Fig 1: Identifying Coupling Retainer, Spacer, O-Ring Seals, And Quick Disconnect Coupling Housing
    G06133237Courtesy of FORD MOTOR CO.
  3. Push the heater water hose with a quick disconnect coupling onto the tube.
    Fig 2: Pushing Heater Water Hose With Quick Disconnect Coupling Onto Tube
    G06133238Courtesy of FORD MOTOR CO.
  4. Make sure the coupling is fully engaged by lightly pulling on the heater water hose.
scientia non olet · About LEMON Manuals