LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (HVAC - Climate Control System - General Information And Diagnostics -- F250-F550 Super Duty) >> Diagnosis And Testing >> Climate Control System >> Component Tests >> A/C Compressor - External Leak Test

A/C Compressor - External Leak Test

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the adapter from the A/C Flush Adapter Kit on the port of the A/C compressor, using the existing manifold retaining bolt.
  2. Connect the high and low pressure lines of a manifold gauge set or a refrigerant recovery/recycling station to the corresponding fittings on the adapter.
  3. Attach the center hose of a manifold gauge set to a refrigerant container standing in an upright position.
  4. Open the low pressure gauge valve, the high pressure gauge valve and the valve on the refrigerant container to allow the refrigerant vapor to flow into the A/C compressor.
  5. Using the Refrigerant Leak Detector, check for leaks at the compressor shaft.
  6. If an external leak is found, install a new A/C compressor.
  7. When the leak test is complete, recover the refrigerant from the compressor.
scientia non olet · About LEMON Manuals