Normal Operation: Notes
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
The PCM monitors the secondary generator output via the generator 2 monitor (GENMON2) circuit (generator field terminal circuit). If the PCM cannot read the GENMON2 circuit due to an open or short to ground, when the engine speed is greater than approximately 2, 000 rpm, the secondary generator defaults to a steady voltage of approximately 13.5 volts and the PCM sends a message over the High Speed Controller Area Network (HS-CAN) to the Instrument Panel Cluster (IPC) through the Body Control Module (BCM) to illuminate the charging system warning indicator lamp.
- DTC P163C (Generator B Field Terminal Circuit Low) - The PCM sets this DTC if the GENMON circuit is shorted to ground, the "A" sense circuit is open or the B+ circuit is open. This DTC also sets by a faulted PCM or generator.
- DTC P163D (Generator B Field Terminal Circuit High) - The PCM sets this DTC if the GENMON2 circuit is open or shorted to power. This DTC can also be set by a faulted PCM or generator.
This pinpoint test is intended to diagnose the following:
- Fusible link
- Wiring, terminals or connectors
- Engine, generator and battery grounds
- Battery
- Secondary generator
- PCM