LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 318 (Automatic Transmission - 5R110W (TORQSHIFT-R)) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the OSS sensor.
    1. Lubricate the O-ring with transmission fluid and install the OSS sensor.
    2. Install the bolt.
      • Tighten to 9 Nm (80 lb-in).
        Fig 1: Identifying OSS Sensor And Bolt
        G06141130Courtesy of FORD MOTOR CO.
  2. Connect the OSS sensor connector.
    Fig 2: Locating OSS Sensor Connector
    G06140648Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals