LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Engine Mechanical - 6.8L) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty and 2013 Ford F-450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the front oil level indicator and tube bolt.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Remove the rear oil level indicator and tube bolt.
    • To install, tighten to 10 Nm (89 lb-in).
  4. Remove the oil level indicator and tube from the cylinder block.
    • Discard the O-ring seal.
  5. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals