LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Engine Mechanical - 6.2L) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Installation

Oil Level Indicator and Tube: Installation

WARNING: This page is about a different car, the 2013 Ford F-350 Super Duty and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Lubricate the new oil level indicator tube O-ring seal with clean engine oil prior to installation.

    Using a new O-ring seal, install the oil level indicator tube and the bolt.

    • Tighten to 10 Nm (89 lb-in).
  2. Install the oil level indicator.
  3. Install the RH engine support insulator-to-cylinder block bracket. For additional information, refer to ENGINE SUPPORT INSULATORS .
  4. Install the RH exhaust manifold. For additional information, refer to EXHAUST MANIFOLD - RH .
scientia non olet · About LEMON Manuals