Resonator - Gasoline Engines: Removal
WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 2 exhaust Y-pipe with dual catalytic converter-to-resonator bolts.
- Loosen the 2 exhaust Y-pipe with dual catalytic converter-to-resonator Torca® clamp nuts.
- Loosen the resonator-to-muffler Torca® clamp or, if equipped, the resonator-to-exhaust intermediate pipe Torca® clamp.
- If equipped, disconnect the exhaust intermediate pipe isolator and the front muffler isolator.
- Disconnect the resonator from the isolator.
- Remove the resonator.