LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Sunroof - Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Motor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel motor has been removed from the roof opening panel assembly, a new roof opening panel motor has been installed or when a new roof opening panel frame has been installed. For additional information, refer to ROOF OPENING PANEL MOTOR INITIALIZATION .
  1. Lower the rear of the headliner. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
    • For SuperCab vehicles, remove the B-pillar trim panels.
    • For SuperCrew vehicles, remove the C-pillar trim panels.
    • If equipped, remove the 3 headliner pin-type retainers.
    • If equipped, remove the 2 headliner garment hooks.
  2. Disconnect the roof opening panel motor electrical connector.
  3. Remove the 3 roof opening panel motor screws.
    • To install, tighten to 4 Nm (35 lb-in).
  4. Remove the roof opening panel motor.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals