LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 301 (Exterior Trim & Ornamentation) >> Removal And Installation >> Power Running Board (PRB) Step >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. NOTE: If the Power Running Board (PRB) cannot be extracted, extend the running board by hand.

    Extend the PRB.

  3. Remove the 2 front and 2 rear PRB bracket-to-step screws and the PRB step
    • To install, tighten to 12 Nm (106 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals