Removal and Installation
WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
Standard
- Remove the 2 rear fender moulding screws.
- Remove the 4 rear fender moulding pin-type retainers.
- Starting at the front of the fender moulding, pull outward to release it from the fender.
SVT Raptor
- Remove the 6 rear fender moulding pin-type retainers.
- Remove the rear fender moulding screws.
-
NOTE: Pry directly on the pin-type retainer. Do not pry on the fender moulding. Failure to follow this direction may result in damage to the component.
Using a non-marring tool, starting at the front of the rear fender moulding, pry outward on the pin-type retainers by pushing the handle toward the fender.
- Remove the rear fender moulding.
All vehicles
- To install, reverse the removal procedure.