LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Rear Suspension -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs - Dual Rear Wheel (DRW) >> Installation

Wheel Studs - Dual Rear Wheel (DRW): Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud aligning the serrations in the wheel extension made by the original wheel stud.
    Fig 1: Installing Wheel Stud
    G07966960Courtesy of FORD MOTOR CO.
    2. NOTE: Make sure to use washers that have an ID that is larger than the OD of the wheel stud serrations. Use enough washers (approximately 4) to allow the wheel stud to fully seat against the hub flange.
    Fig 2: Locating Wheel Nut On Wheel Stud
    G06064890Courtesy of FORD MOTOR CO.
  2. Place 4 washers over the outside end of the wheel stud and thread a standard wheel nut with the flat side against the washers. Tighten the wheel nut until the wheel stud seats against the back side of the wheel extension.
  3. Remove the wheel nut and washers.
scientia non olet · About LEMON Manuals