LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Automatic Transmission External Controls) >> Removal And Installation >> Selector Lever Knob >> Installation

Selector Lever Knob: Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the SelectShift™ and the Tow/Haul electrical connectors and install the selector lever knob.
  2. Install a new LH selector lever knob screw.
    Fig 1: Locating LH Selector Lever Knob Screw
    G08341254Courtesy of FORD MOTOR CO.
  3. Install a new RH selector lever knob screw.
    Fig 2: Locating RH Selector Lever Knob Screw
    G08341253Courtesy of FORD MOTOR CO.
  4. Install a new LH selector lever knob cover.
    Fig 3: Installing LH Selector Lever Knob Cover
    G08341257Courtesy of FORD MOTOR CO.
  5. Install a new RH selector lever knob cover.
    Fig 4: Installing RH Selector Lever Knob Cover
    G08341258Courtesy of FORD MOTOR CO.
  6. Connect and install the floor console upper finish panel.
    Fig 5: Identifying Floor Console Upper Finish Panel
    G08341259Courtesy of FORD MOTOR CO.
  7. Install the instrument panel to floor console finish panel.
    Fig 6: Locating Instrument Panel To Floor Console Finish Panel
    G07412490Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals