LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine System - General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Crankshaft End Play

Crankshaft End Play

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS CHART

G07950734
 Dial Indicator Gauge with Holding Fixture
100-002 (TOOL-4201-C) or equivalent
NOTE: Refer to the appropriate ENGINE article service information for the specification.
  1. Install the Dial Indicator Gauge with Holding Fixture.
  2. Position the crankshaft to the rear of the cylinder block.
  3. Zero the Dial Indicator Gauge.
  4. Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
Fig 1: Checking Crankshaft End Play Using Dial Indicator Gauge
G06064065Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals