LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine System - General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Connecting Rod Cleaning

Connecting Rod Cleaning

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not use a caustic cleaning solution or damage to connecting rods can occur.
    NOTE: The connecting rod large end is a matched set. The connecting rod cap must be installed on the original connecting rod in the original position. Do not reverse the cap. Parts are not interchangeable.
  1. Mark and separate the parts and clean with solvent. Clean the oil passages.
Fig 1: Locating Connecting Rod Large End Mark
G06064085Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals