Connecting Rod Bearing Journal-to-Bearing Clearance

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to the appropriate ENGINE article service information for the specification.

NOTE: The crankshaft connecting rod journals must be within specifications to check the connecting rod bearing journal clearance.

Remove the connecting rod bearing cap.
Position a piece of Plastigage across the bearing surface.

Fig 1: Locating Connecting Rod Bearing Journal Clearance
Courtesy of FORD MOTOR CO.

NOTE: Do not turn the crankshaft during this step.

Install and tighten to specifications, then remove the connecting rod bearing cap.
Measure the Plastigage to get the connecting rod bearing journal clearance. The Plastigage should be smooth and flat. A changing width indicates a tapered or damaged connecting rod or connecting rod bearing.

Fig 2: Measuring Plastigage To Get Connecting Rod Bearing Journal Clearance

Courtesy of FORD MOTOR CO.