LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine System - General Information -- F250-F550 Super Duty (Gasoline)) >> General Procedures >> Camshaft End Play - OHC Engines

Camshaft End Play - OHC Engines

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, and 2012 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOLS CHART

G07950734
 Dial Indicator Gauge with Holding Fixture
100-002 (TOOL-4201-C) or equivalent
NOTE: Refer to the appropriate ENGINE article service information for the specification.
  1. Using the Dial Indicator Gauge with Holding Fixture, measure the camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the Dial Indicator Gauge.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install a new camshaft and recheck end play.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head.
    Fig 1: Checking Camshaft End Play
    G06064054Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals