LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Anti-Theft System - Passive Anti-Theft System) >> General Procedures >> Passive Anti-Theft System (PATS) Parameter Reset >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
G08343664
 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
  1. Turn the key from the OFF position to the RUN position.
  2. From the scan tool, enter TOOLBOX. Select BODY - SECURITY - PATS Functions and follow the Integrated Diagnostic System (IDS) onscreen instructions to ENTER SECURITY ACCESS.
  3. NOTE: If the Body Control Module (BCM) was replaced on vehicles equipped with PATS, at least two keys must be programmed to the BCM. After completing step 3, do not disconnect the scan tool and follow the Erase All Keys and Program Two Keys procedure.

    From the scan tool, select "Parameter Reset" and follow the IDS on-screen instructions.

scientia non olet · About LEMON Manuals