LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 265 (Body Panel System - Front End Body Panels) >> Removal And Installation >> Fender Splash Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Both splash shields 

  1. If equipped, remove the fender moulding. For additional information, refer to EXTERIOR TRIM & ORNAMENTATION .
  2. Remove the wheel and tire. For additional information, refer to WHEELS & TIRES

    LH splash shield 

  3. Open the hood and remove the 5 wiring harness pushpins attached to the splash shield in the engine compartment.
  4. Remove the 3 splash shield pushpins and the 5 splash shield screws.
  5. Partially lower the splash shield and remove the 2 air box deflector pushpins from the engine side of the splash shield.

    RH splash shield 

  6. Open the hood and remove the 4 wiring harness pushpins attached to the splash shield in the engine compartment.
  7. Remove the 3 splash shield pushpins and the 5 splash shield screws.

    Both splash shields 

  8. Remove the splash shield.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals