Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: 40 percent and 60 percent rear seat cushion covers are removed in the same manor.

NOTE: For parts identification and location, refer to SEAT - EXPLODED VIEW, REAR, SUPERCAB in this information.

Remove the rear seat cushion. For additional information, refer to SEAT - REAR, SUPERCAB in this information.
Release the cushion cover J-clip.
NOTE: Use care when separating the seat cushion cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.

Invert the cushion cover to the row of hog rings.
Remove the hog rings.
Invert and remove the cushion cover.
- If needed, separate and remove foam pad from the cushion frame.
To install, reverse the removal procedure.