LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Seat System - Seats) >> Removal And Installation >> Front Seat Motor Cable >> Removal

Front Seat Motor Cable: Removal

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.
NOTE: Typical driver seat shown in illustration, others similar.
  1. Remove the seat. Refer to SEAT - FRONT .
  2. If equipped.
    Fig 1: Removing Front Seat Adjusting Lever Retaining Clips
    G08344013Courtesy of FORD MOTOR CO.
  3. If equipped.
    Fig 2: Locating Seat Control Connector
    G08344014Courtesy of FORD MOTOR CO.
  4. Remove the screws and side shield.
    Fig 3: Locating Side Shield Mounting Screws
    G08344015Courtesy of FORD MOTOR CO.
  5. Fig 4: Disconnecting Front Seat Motor Cable
    G08344016Courtesy of FORD MOTOR CO.