LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Seat System - Seats) >> Removal And Installation >> Dual Climate Controlled Seat Module (DCSM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. When installing a new Dual Climate Controlled Seat Module (DCSM), carry out the appropriate steps in the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION SYSTEM .
  2. Remove the front passenger seat. For additional information, refer to SEAT - FRONT  in this information.
  3. Disconnect the 3 DCSM electrical connectors.
    • Release the 2 locking wedges.
    • Disconnect the 3 connectors.
      Fig 1: Releasing Locking Wedges On DCSM Electrical Connectors
      G06077113Courtesy of FORD MOTOR CO.
  4. Remove the 2 screws and DCSM.
  5. To install, reverse the removal procedure.
  6. If a new DCSM has been installed, carry out the appropriate steps to complete the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION SYSTEM .
scientia non olet · About LEMON Manuals