Seat Wire Harness Routing: Notes
WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
- Install the front passenger seat wire harness. For correct installation, refer to the following views. Retainers and electrical connectors are numbered in order of assembly. Match the numbers in the Retainer and Connector Location Views and attach accordingly.
- For manual seat illustrations, refer to MANUAL PASSENGER SEAT TRACK .
- For heated seat illustrations, refer to POWER PASSENGER HEATED SEAT .
- For climate controlled seat illustrations, refer to POWER PASSENGER CLIMATE CONTROLLED SEAT .
-
NOTE: Illustration shows Occupant Classification System (OCS) weight sensor bolts in their installed position with the seat in the vehicle (arrow indicates front).
Verify the correct passenger seat OCS weight sensor bolt electrical connector positions using the illustration.
- For correct identification and placement of the 2 OCS weight sensor bolt electrical connectors, use the wire colors identified in the SUPPLEMENTAL RESTRAINT SYSTEM . Connecting the incorrect connector to a sensor causes DTCs to set and results in an unsuccessful OCS System Reset.