Brake Vacuum Pump: Removal

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Remove the RH front fender inner splash shield. Refer to BODY PANEL SYSTEM - FRONT END BODY PANELS .
Fig 1: Removing Vacuum Supply Hose From Brake Vacuum Pump
Courtesy of FORD MOTOR CO.
NOTE: Do not use excessive force when removing the vacuum pump or the vacuum pump oil tube may be dilodged from the pump causing internal oil seal damage to the pump. If the oil tube becomes dislodged from the pump, a new vacuum pump must be installed.

NOTE: The upper/inboard vacuum pump bolt will remain in the vacuum pump housing when removing the vacuum pump.

Fig 2: Locating Upper/Inboard Vacuum Pump Bolt
Courtesy of FORD MOTOR CO.