Special Tool(s)

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Brake Adjusting Gauge
206-D002 (D81L-1103-A) or equivalent

NOTE: Make sure the parking brake is fully released.

Using the release handle, release the parking brake control.
Remove the rear brake disc. For additional information, refer to REAR DISC BRAKE SYSTEM .
Using the Brake Adjusting Gauge, measure the ID of the drum portion of the rear brake disc and set the locking screw.
- Record the measurement.
  
  Fig 1: Measuring Inside Diameter Of Drum Portion Of Rear Brake Disc Using Brake Adjusting Gauge
  Courtesy of FORD MOTOR CO.
Place the Brake Adjusting Gauge over the widest diameter of the parking brake shoes.

Fig 2: Measuring Parking Brake Shoes Widest Diameter Using Brake Adjusting Gauge
Courtesy of FORD MOTOR CO.
Adjust the parking brake shoe clearance to 0.59 mm (0.023 in) less than the ID of the drum portion of the rear brake disc.
- Rotate the parking brake shoe adjuster to achieve the correct parking brake shoe-to-brake disc clearance.
Install the rear brake disc. For additional information, refer to REAR DISC BRAKE SYSTEM .
Test the parking brake for normal operation.