Driveshaft - Front: Removal

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position the vehicle on a hoist. Refer to JACKING & LIFTING .
If equipped.

Fig 1: Locating Splash Shield Fasteners
Courtesy of FORD MOTOR CO.
Fig 2: Locating Driveshaft Flange Index-Mark
Courtesy of FORD MOTOR CO.
Fig 3: Locating Driveshaft Flange Index-Mark
Courtesy of FORD MOTOR CO.
NOTE: If new bolts are not available, the old bolts and washers can be reused if they are not damaged. When reusing old bolts, the threads need to be cleaned and loctite has to be used on the threads of each bolt.

To install, tighten to 55 Nm (41 lb-ft).

Fig 4: Locating Driveshaft Flange Bolts And Washers
Courtesy of FORD MOTOR CO.
NOTE: If new bolts are not available, the old bolts and washers can be reused if they are not damaged. When reusing old bolts, the threads need to be cleaned and loctite has to be used on the threads of each bolt.
- To install, tighten to 55 Nm (41 lb-ft).
  
  Fig 5: Locating Driveshaft Flange Bolts And Washers
  Courtesy of FORD MOTOR CO.
- To install, tighten to 55 Nm (41 lb-ft).
  
  Fig 6: Locating Sway Bar Fasteners
  Courtesy of FORD MOTOR CO.
Fig 7: Identifying Driveshaft Assembly
Courtesy of FORD MOTOR CO.