Messaged Inputs

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Module messaging is the standard for sending and receiving information required to operate the IPC. All messages required for the IPC to operate are received over the High Speed Controller Area Network (HS-CAN). For a list of module messages with the message origination sources, refer to MODULE COMMUNICATIONS NETWORK .

Listed below is a partial list of status and information messages that the IPC requires from other vehicle inputs:

ABS
- ABS braking
- Roll Stability Control (RSC®)
- Traction control
Base brake system
- Brake fluid level status
- Parking brake status
Body
- Door ajar
- Supplemental Restraint System (SRS)
- Tire Pressure Monitoring System (TPMS)
Lighting system
- LH/RH turn
- High beam
Powertrain
- Charging system
- ELD
- Engine emission system
- Engine oil pressure
- Engine rpm
- Engine temperature
- Four-Wheel Drive (4WD)
- Tow haul status
- Transmission range
- Vehicle speed