Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup, 2012 Ford F550 Super Duty, 2012 Ford F450 Super Duty, and 2012 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Open the glove compartment.
Release the glove compartment stop and lower the glove compartment.

Fig 1: Locating Glove Compartment Stop And Glove Compartment
Courtesy of FORD MOTOR CO.
If equipped, remove the telematics module. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS .
Remove the 2 Inertia Fuel Shutoff (IFS) switch bolts.
- To install, tighten to 2 Nm (18 lb-in).
Disconnect the IFS switch electrical connector and remove the IFS switch from the vehicle.
To install, reverse the removal procedure.