Ball Joint - Lower: Removal

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Remove the wheel knuckle. For additional information, refer to WHEEL KNUCKLE .
Remove and discard the lower ball joint snap ring.
Using the C-Frame and Screw Installer/Remover and Ball Joint Remover, remove and discard the lower ball joint.

Fig 1: Removing Lower Ball Joint
Courtesy of FORD MOTOR CO.

SVT Raptor
Using a clean shop towel and the specified surface cleaner, clean the lower arm ball joint bore and inspect for cracks or damage before installing a new ball joint. If there is evidence of cracks or damage, a new lower arm must be installed.