Special Tool(s)

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Feeler Gauge Set
303-D027 (D81L-4201-A) or equivalent

NOTE: Use care when fitting piston rings to avoid possible damage to the piston ring or the cylinder bore.

NOTE: Piston rings should not be transferred from one piston to another.

NOTE: Refer to the appropriate Engine information for the specification.

NOTE: The cylinder bore must be within specification for taper and out-of-round.

Use a piston without rings to push a piston ring in a cylinder to the bottom of ring travel.

Fig 1: Pushing Piston Ring In Cylinder To Bottom Of Ring Travel Using Piston Without Rings
Courtesy of FORD MOTOR CO.
Use the Feeler Gauge Set to measure the top piston ring end gap and the second piston ring end gap.

Fig 2: Measuring Piston Ring End Gap Using Feeler Gauge
Courtesy of FORD MOTOR CO.