Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Select parts are available for repair of some individual tailgate step components.

Lower the tailgate and open the assist step.
Remove the 2 tailgate step inside bolts.
- To install, tighten to 25 Nm (18 lb-ft).
Fig 1: Locating Tailgate Step Inside Bolts
Courtesy of FORD MOTOR CO.
Remove the 4 tailgate step upper bolts.
- To install, tighten to 25 Nm (18 lb-ft).
Fig 2: Locating Tailgate Step Upper Bolts
Courtesy of FORD MOTOR CO.
Remove the 2 tailgate step nab pin nuts.
- To install, tighten to 11 Nm (97 lb-in).
Fig 3: Locating Tailgate Step Nab Pin Nuts
Courtesy of FORD MOTOR CO.
Remove the tailgate step.
To install, reverse the removal procedure.
- Adjust as necessary. For additional information, refer to Tailgate Step Adjustment in this information.