LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Exterior Trim & Ornamentation - F150) >> Diagnosis And Testing >> Window Molding >> Installation

Window Molding: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove all remaining adhesive tape on the mating surfaces of the door and apply new adhesive tape.
    2. NOTE: Make sure the forward edge of the molding is underneath the glass run lip.
  2. Install the window molding on the edge of the door, engage the groove then gently press down to engage the clips and tape.
  3. Install the outer belt molding.
scientia non olet · About LEMON Manuals