Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Standard
- Remove the 2 rear fender molding screws.
- Remove the 4 rear fender molding pin-type retainers.
- Starting at the front of the fender molding, pull outward to release it from the fender.
SVT Raptor
- Remove the 6 rear fender molding pin-type retainers.
- Remove the rear fender molding screws.
- Using a non-marring tool, starting at the front of the rear fender molding, pry outward on the pin-type retainers by pushing the handle toward the fender.
- Remove the rear fender molding.
All vehicles
- To install, reverse the removal procedure.
NOTE:
Pry directly on the pin-type retainer. Do not pry on the fender molding. Failure to follow this direction may result in damage to the component.