Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Ford oval emblem must be replaced, as the tabs break during removal.
- Remove the Ford oval emblem by prying the emblem away from the emblem bezel with a suitable pry tool.
- Remove the 2 emblem bezel bolts.
- Disconnect the electrical connector.
- Remove the video camera and emblem bezel from the tailgate.
- Remove the 2 video camera screws.
- Remove the video camera.
- To install, reverse the removal procedure.
NOTE:
The video camera electrical connector is located underneath the vehicle rear bumper and between the spare tire. There is no need to remove the tailgate access panel in the removal of the video camera.