LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Windows And Glass - Glass, Frames And Mechanisms - F150) >> Removal And Installation >> Window Glass - Rear Door, SuperCrew >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the window control switch. For additional information, refer to WINDOW CONTROL SWITCH - REAR  .
  2. Remove the rear door trim panel. For additional information, REFER to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the rear door mounted speaker. For additional information, REFER to INFORMATION AND ENTERTAINMENT SYSTEMS .
  4. Remove the rear door interior molding.
  5. Position aside the rear door watershield.
  6. Temporarily install the window control switch to raise or lower the window as necessary to access the glass-to-regulator assembly bolts.
  7. Loosen the rear door window glass-to-regulator assembly bolts.
    • To install, tighten to 11 Nm (97 lb-in).
  8. Tape the window in position, then lower the rear door window regulator to the full downward position.
  9. Remove the rear door window glass.
    • Pull the rear door window glass out through the top inboard side of the door.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals