Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The front window motor must be de-initialized, then initialized whenever the LH front or RH front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.
- Remove the front door window glass. For additional information, refer to WINDOW GLASS - FRONT DOOR .
- Remove the exterior rear view mirror. For additional information, REFER to REAR VIEW MIRRORS .
- Remove the front door outer belt molding. For additional information, REFER to EXTERIOR TRIM AND ORNAMENTATION .
- Remove the front door glass top run.
- Remove the front door glass top run through the top opening of the front door.
- To install, reverse the removal procedure.
- Initialize the front window motor. For additional information, refer to WINDOW MOTOR INITIALIZATION .