LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Mustang Base, 2D Coupe, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Transfer Case -- F150) >> In-Vehicle Repair >> Transfer Case Rear Output Shaft Seal >> Installation

Transfer Case Rear Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2012 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Input Shaft Oil Seal Installer, install the rear output shaft seal.
    Fig 1: Installing Rear Output Shaft Seal
    G06128037Courtesy of FORD MOTOR CO.
  2. Install the rear driveshaft. For additional information, REFER to DRIVESHAFT .
scientia non olet · About LEMON Manuals